Bilt Hamber Phat Neut 1L

Phat-Neut® is a pH-neutral, multi-mode rinseless wash that will remove real-world traffic film with cleaning power surpassing all other pH7 cleaners.

Using Bilt-Hamber’s Lift-Mode® Technology, Phat-Neut® lowers surface tension to wet, encapsulate and lift mineral-rich road film, brake dust, tyre residue, insects, bird lime and general grime away from the surface without relying on caustic alkalinity, solvents or aggressive chemistry.

It can be used as a rinseless wash, waterless cleaner, pressure-washer or pump-spray pre-wash, wheel cleaner, or targeted contamination remover. Its optional Dry-On® Mode allows cleaning activity to intensify as water evaporates when used on heavy dirt films.

How to use

What is Dry-On®?

Dry-On® is an optional severe-dirt cleaning mode built into Phat-Neut®. Unlike normal cleaners, Phat-Neut® can be allowed to visibly dry into heavy, continuous dirt film. This allows the product to remain active within the contamination for longer, helping to lift, loosen and release traffic film before rinsing.

Dry-On® is possible because Phat-Neut® is a neutral-pH cleaner and because of the way it wets, buffers water and captures ions. However, Dry-On® should not be abused or treated as a general instruction to let product dry on any surface. Always follow the instructions and use it only in the correct conditions.

Dry-On® is only for heavily soiled exterior surfaces where there is enough dirt film for the product to dry into.

What is Lift-Mode®?

Lift-Mode® is the normal wet application method. Phat-Neut® wets, lifts, encapsulates and isolates

contamination from the surface, helping dirt release safely during rinsing or the bucket wash stage.

Use Lift-Mode® where the dirt level is not heavy enough for Dry-On®, or where the product should remain wet during use.

When to use Dry-On®

Use Dry-On® only on exterior surfaces with heavy, continuous, absorbent dirt film.

Suitable examples include:- Heavy winter road film- Dirty lower panels- Heavily contaminated wheels- Panels with a continuous, visible dirt layer Dry-On® suitability test

Before using Dry-On®, first check that the level of dirt is sufficient.

Mix Phat-Neut® at 2-4% and place a small drop onto the target dirt film.

If the drop begins to spread as it infiltrates the dirt and is absorbed into the film, the dirt level is suitable for Dry-On® use.

Allow the test area to visibly dry, then rinse or wipe the test area and inspect carefully. If the surface is

unaffected by Dry-On®, proceed.

If the drop does not spread into the dirt film, or the surface is only lightly or patchily soiled, use Lift-Mode® instead.

When not to use Dry-On®

Do not allow Phat-Neut® to dry on:- Clean panels- Lightly soiled panels- Patchy dirt- Recently rinsed surfaces- Exposed finish areas where there is insufficient dirt film- Interior surfaces- Leather, faux leather, screens, or delicate trim- Soft furnishings